The same tool can be used to drive out old bearings as well. strokersonoma, There are 2 sets of cam bearings available for the LSx motors. Theyre especially good for engines that run at medium-to-high revs. Clevite H-Series main bearings were developed primarily for NASCAR racing, but are well suited to other types of competition engines as well. The removable bearing die allows you to install the first three bearings, and then reverse the tool in the block to install the last two. CLEVITE H-Series Main Bearing Set - GM LS1. Sometimes called a cam bearing driver, cam bearing tool, or knocker, this tool has a bearing die and centering cone sized specifically to fit the cam journals of Gen 3 LS engines. The video provides several tips for cleaning, for how to determine bearing order and orientation, and for test-fitting the camshaft.īrian and Mike also share how to operate the Summit Racing cam bearing installation tool. This was evident from the fact that the LM7. They’re using a late-Gen 3 LS engine block that they rescued from the returns bin and turned into a project 408, but the same techniques work on all of these blocks. Despite similar specs to the LS2 (increased intake lift), low-speed power production with the LS3 cam was down compared with the LS2. In today’s video from our friends at Summit Racing, Brian and Mike demonstrate the proper way to install cam bearings in LS Gen 3, LS Gen 4, or LT Gen 5 engines. If you’ve done everything right, once the camshaft is in place, it should spin by hand with ease! If you’re still unsure which type of ls cam bearing tool is best for you, I recommend comparing the characteristics and functionalities of the ls cam bearing tool listed above. They also must be driven into position perfectly straight, with the oil galley holes lined up. Application: for Chevy G/M LS Engine, LS1, LS2,LS3,LS6, LQ9 Cam Bearing Installation Tool: This tool is used to remove and install cam bearings. Camshaft bearings are sized to fit into the cam housing bore in a specific order.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |